NetBase for MPE Reference Guide

Chapter 3
3-12
SPOOL - Use S' and J' on incoming
This parameter tells NetBase to set the job/session id numbers on incoming spool files to J'nnn or
S'nnn. This convention reduces ambiguity between local and remote spool files. This parameter
takes effect when the START SPOOLING command is issued in NBCTRL.
Default = Y
SPOOL - Change user on incoming
Setting this parameter to Y preserves the user information from the originating computer. If it is set
to N, all transferred spool files are created with the user specified as MGR.NETBASE. This parameter
takes effect when the START SPOOLING command is issued in NBCTRL.
Default = Y
SPOOL - Change jsname to node name
If the Change user on incoming flag is set to Y and this value is set to Y, the job/session name of the
creating user will be changed to the node name where the creating user exists. The job/session
name can be displayed with NBSpool and other spooling utilities. This parameter takes effect when
the START SPOOLING command is issued in NBCTRL.
Default = N
SPOOL - Using SpoolMate
This parameter should be set to Y when importing spool files to a system that uses Unison's
SpoolMate software. In all other cases, set this value to N. This parameter takes effect when the
START SPOOLING command is issued in NBCTRL.
Default = N
SPOOL - Spooling Export Priority
This parameter sets the execution priority of all Spooling Export processes. The default is linear
queue 152. Any numeric value or BS, CS, DS, or ES is valid. This parameter takes effect when a
Spooling Export process starts.
Default = 152
Minimum = 50
Maximum = 255