NetBase for MPE Reference Guide

Chapter 3
3-4
To define the network nodes:
1. To define the nodes in your network for NetBase, use the ADD command, specifying the
number of the node you wish to define. Remember to define the current node. You are
prompted for details concerning each node.
C> ADD n
2. Tell NetBase which node is the local node:
C> MODIFY GLOBAL
3. Exit CONFIG:
C> EXIT
∗> EXIT
4. Repeat steps 1 to 3 on each node.
Note. As an alternative, you can run NBCTRL with an INFO parameter. This allows
you to access CONFIG when someone else is accessing NBCTRL.
:RUN NBCTRL.PUB.NETBASE;INFO="CONFIG"