NBSpool for MPE Reference Guide

NBSpool Output Commands
3-13
ARCPURGE
The
ARCPURGE
command purges selected spool files that were archived with the
ARCHIVE
command. Any subset of spool files in the archive may be purged. Only the archive’s creator may
use the
ARCPURGE
command.
Pressing
Ctrl+y
will terminate the archive purging process. If a fileset was specified, any fully
processed archive files will be left in their newly cleaned state. Any archive files that have yet to be
fully processed will be left intact, without any spool files being purged.
ARCPURGE Command Syntax
O> ARCPURGE [subset] ;FILE=fileset
[;ASK ]
User Tip. This command may be abbreviated to
ARCP
.
ARCPURGE Parameters
Parameter Description
subset
This parameter specifies the subset of spool files to be unarchived. Turn to
Chapter 2 for more information on using subsets. The forms message selection
is not supported.
Fileset
This parameter specifies a file name or file set (like
:LISTF
) which specifies the
file(s) which will have selected entries removed.
ASK
If this parameter is specified, then the list of files which qualified for
PURGING
will be presented.