NBSpool for MPE Reference Guide

Chapter 7
7-18
Error Message Explanation/Action
THIS PARAMETER IS NOT APPLICABLE IN
OUTPUT MODE
You may not specify this parameter during
OUTPUT
mode. Review the
HELP
output
command for valid parameters in the
OUTPUT
mode.
*2
THIS PARAMETER IS NOT VALID FOR
GATEWAY DESTINATIONS
You may not specify this parameter when using
Gateway destinations.
*2
THIS PARAMETER IS NOT VALID FOR HP-
UX DESTINATION NODES
The parameter you have specified does not apply
for this command when you are also specifying
HP_UX
destinations.
*2
THIS PARAMETER IS NOT VALID FOR HP
3000 DESTINATION NODES
The parameter you have specified does not apply
for this command when you are also specifying
HP 3000 destinations.
*2
THIS PARAMETER IS NOT VALID FOR
LASER PRINTER DESTINATIONS
You may not specify this parameter when
specifying a laser printer destination.
*2
THIS PARAMETER IS NOT VALID FOR lpr
DESTINATION NODES
You may not specify this parameter when
specifying the LPR destination.
*2
THIS PARAMETER IS NOT VALID FOR
NETWARE QUEUES
You may not specify this parameter in connection
with NetWare queues.
*2
THIS PARAMETER IS NOT VALID FOR NFS
DESTINATIONS
You may not specify this parameter in connection
with an NFS destination.
*2
THIS PARAMETER IS NOT VALID IN INPUT
MODE
You may not specify this parameter during
INPUT
mode. Review the
HELP
input command for
parameters available during
INPUT
mode.
*2
THIS PARAMETER IS ONLY VALID FOR
THE NATIVE MODE SPOOLER
You may not use this parameter if your system is
operating on an MPE/XL version which is less
than 2.1.
THIS PARAMETER REQUIRES OP
CAPABILITY
You may not execute this command with this
parameter without
OP
capability. See your system
manager for help.
*2
THIS PARAMETER REQUIRES SM
CAPABILITY
You must have
SM
capability to use this
parameter. See your system manager for help.
*2
THIS TERMINAL DOES NOT SUPPORT AN
ATTACHED PRINTER
You may not specify a slave printer as a
destination when this terminal does not support
one.
*2