NBSpool for MPE Reference Guide

Chapter 7
7-12
Error Message Explanation/Action
MISSING “TO node” SPECIFICATION
You must specify the node to which you want
this spool file to go.
*2
MISSING FILE NAME
You must specify a filename with this command.
*2
MISSING NBSPOOL CONFIGURATION
FILE !
NBSpool cannot locate the configuration file.
Restore it from tape, or contact Quest Technical
Support to transfer one to you.
*2
MISSING NETBASE TAPE LABEL
The tape you loaded does not have a NetBase
label. You may not use NBSpool to restore from
a tape lacking a NetBase label.
MISSING NETWARE QUEUE NAME
NBSpool needs to know the NetWare queue
name.
*2
MORE THAN ONE SHOW FORMAT
SPECIFIED
You may specify only one
SHOW
format per
SHOW
command.
*2
MUST BE A VALID NETWARE NAME NO
LONGER THAN ! CHARACTERS
The NetWare name you specified is too long.
*2
NBSPOOL NETWARE MODULE IS NOT
INSTALLED
You have not installed the NBSpool NetWare
module. Call your Quest Sales Representative for
more information.
*2
NBSPOOL RECEIVING PROCESS NOT
RUNNING ON REMOTE NODE
Ask your network administrator to stream the
NBSpool receiving job on the remote node.
*2
NESTED XEQ COMMANDS NOT ALLOWED
You may not
XEQ
a file from within an
XEQ
file.
*2
NETWARE/XL IS NOT INSTALLED ON THIS
SYSTEM
Without NetWare/XL, this command may not be
performed.
*2
NETWORK ERROR ON RPMCREATE: IS NS
STARTED ON REMOTE NODE?
Ask the network administrator to verify that
NS
is
running on the remote node.
*2
NETWORK READ FAILED
See error message for more information.
NETWORK SEND FAILED
See error message for more information.
NETWORK SERVICES (NS) ARE NOT
INSTALLED ON THIS SYSTEM
Without Network Services installed, you may not
issue this command successfully.
*2