NBSpool for MPE Reference Guide

Troubleshooting NBSpool
7-3
Error Messages
The following NBSpool error messages are listed in alphabetical order. Some error messages
require that you contact Quest Technical Support for correction. If you encounter a message that is
not listed here, please contact Quest Technical Support. Make sure that you note the error message,
any details included in the message, and also the version of NBSpool that you are running.
A few of the following error messages have some similarities. To reduce the repetition of the
explanations, the following codes have been assigned:
*1
When NBSpool encounters this message while running as a background job, the job
terminates.
*2
This message sets
JCW=FATAL
. If the job has
IF JCW=FATAL, THEN ABORT
logic, the job
terminates in an error state.
Error Message Explanation/Action
”APPEND” AND “RELEASE” ARE NOT
VALID FOR SPOOK TAPES
You may not specify
APPEND
or
RELEASE
for
SPOOK
tapes.
*2
”AUTO” PARAMETER IS NOT SUPPORTED
FOR THIS COMMAND
You may not specify the
AUTO
parameter for this
command.
*2
”OFF” CANNOT BE SPECIFIED WITH
OTHER SORT SPECIFICATIONS
You may specify
SORT OFF
or
SORT
sortoption
,
but you may not specify
OFF
with a list of other
sort options.
*2
#CANNOT EXECUTE COMMAND:
NETWORK TRANSPORT STOPPED
The command you entered requires the network
to be running. Currently the transport is down.
Ask your network coordinator to start the
network.
*2
#CANNOT EXECUTE COMMAND: NO
RESPONSE FROM REMOTE COMPUTER
The remote computer is not responding. The
command failed as a result. Ask your network
operator to research why the remote computer is
not responding.
*2
#CANNOT EXECUTE COMMAND:
SPECIFIED NODE IS DOWN
The node you requested is not functioning. Ask
your network operator to correct the situation.
*2
Continued