NBSpool for MPE Reference Guide

NBSpool Output Commands
3-93
STORE Parameters
Parameter Description
subset
This parameter specifies the subset of spool files to be stored. Turn to Chapter
2 in this guide for information on working with subsets.
class
The device class of the tape or serial disk device used to store the spool files.
ldev
The logical device number of the tape or serial disk device used to store the
spool files.
outpri
The output priority that all successfully stored spool files will have after being
stored. Must be an integer between
0
and
14
.
APPEND
This parameter appends the current
STORE
set to an existing tape.
ASK
This parameter prompts at each file to include for processing.
PURGE
This parameter purges all spool files stored after the tape is completely
written.
RELEASE
This parameter allows any user to restore any spool file on this tape file.
SPOOK
This parameter causes the tape to be written in
SPOOK
format. This
necessarily causes the store to run much slower. This may not be used with the
APPEND
parameter.
MPE
This parameter causes the tape to be written in MPE
:STORE
format. This
option is valid only on MPE/XL systems with the native mode spooler.
parms
Parameters to be passed to the
:STORE
command, such as
“SHOW=LONG”
or
any other valid
STORE
parms.