MPE/iX Intrinsics Reference Manual (32650-90905)
Chapter 4 79
Command Definitions (ABORTSESS - FCLOSE)
CREATE
(CM) Search the account public library
(SL.PUB.
accountname
) in the account where
formaldesig
is located, then search the system libraries.
10 (NM) Search the group library
(XL.
groupname.accountname
) in the account where
formaldesig
is located, then the account public library,
and then the system libraries.
(CM) Search the group library
(SL.
groupname.accountname
) in the account where
formaldesig
is located, then the account public library,
and then the system libraries.
0 Program loaded in the mode specified when the program
was linked
1 Program loaded in nonprivileged mode
Default: 00
9:1 Control Block; controls where the control blocks of device files are
established and files of type message, RIO, and circular (equivalent to the
NOCB parameter of the RUN command):
0 Establish file control blocks in the process control block
extension (PCBX) area of the CM stack
1 Establish file control blocks in an extra data segment
Default: 0
7:2 Reserved for operating system:
5:2 Stack dump; control the enabling/disabling mechanism where the stack is
dumped in the event of an abort:
00 Stack dump mechanism enabled only at parent level
01 Stack dump mechanism enabled unconditionally
10 Stack dump mechanism enabled only at parent level
11 Stack dump mechanism disabled unconditionally for new
process
Default: 00
4:1 Reserved for operating system:
3:1 DL to initial Q; ignored if formaldesig specifies a native mode program file.
Used for backward-compatibility with MPE V/E-based systems only.
0:3 Reserved for operating system; used only when bits (5:2)=01.
stacksize
16-bit signed integer by value (optional)
(NM) Ignored if
formaldesig
specifies an NM program file (used for
backward-compatibility with MPE V/E-based systems only). The NM stack
is created using NM default values. The CM stack is created using