MPE/iX Error Messages Manual Vol 2 (32650-90902)

78 Chapter2
Native Mode Spooler
(Subsystem 236)
9573 MESSAGE Output spooler, LDEV #\: Spoolfile ! deferred
due to a file error or abnormal condition.
CAUSE 1. The file system reported an error while accessing the
spoolfile.
2. The spooler detected internal spoolfile format
corruption.
ACTION Either of the above reasons generates an appropriate error
message. Correct the situation if possible, then
SPOOLF...;UNDEFER the file to try to reprint the file.
9574 MESSAGE Output spooler, LDEV #\: The spooler was
unable to send a message to its port.
CAUSE The MPE/iX Ports Facility returned an error status to the
spooler. The spooler process will terminate.
ACTION This should never happen. If it does, record all displayed
messages, restart the spooler process and contact your
Hewlett-Packard representative.
9575 MESSAGE Output spooler, LDEV #\: Error while trying
to set spooler state to SUSPEND PENDING.
CAUSE An internal routine which modifies the running state of
the spooler process reported an error status to the spooler.
The spooler process will terminate.
ACTION This should never happen. If it does, record all displayed
messages, restart the spooler process and contact your
Hewlett-Packard representative.
9576 MESSAGE Output spooler, LDEV #\: The spooler was
unable to flush its data to the printer due
to a closed connection socket.
9578 MESSAGE Output spooler, LDEV #\: Error while
performing the TCP graceful release handshake
on the printer connection.
9579 MESSAGE Output spooler, LDEV #\: Error while waiting
for the printer to flush its buffered data.
9580 MESSAGE Output spooler, LDEV #\: Unable to complete
ABORTIO request to the printer connection
socket.
9581 MESSAGE Output spooler, LDEV #\: IPC error while
trying to close the printer connection
socket. IPCSHUTDOWN error !:
9582 MESSAGE Output spooler, LDEV #\: IPC error while
trying to open a printer connection socket.
ADDOPT error !:
9583 MESSAGE Output spooler, LDEV #\: IPC error while