MPE/iX Error Messages Manual Vol 2 (32650-90902)

56 Chapter2
Native Mode Spooler
(Subsystem 236)
5280 MESSAGE No spoolfile exists with the given name or
UFID.
5281 MESSAGE FCLOSE of spoolfile failed.
5282 MESSAGE Internal error mapping from spoolfile
directory entry handle to its address.
5283 MESSAGE Unmatched ITEM NUMBER or ITEM in call to
Spoolfile Management architected interface.
5284 MESSAGE Spoolfile Management encountered an
unexpected escape or trap.
5285 MESSAGE Could not create a virtual object to hold the
input spoolfile directory.
5286 MESSAGE Could not create a virtual object to hold the
output spoolfile directory.
5287 MESSAGE Could not create input spoolfile directory
symbol table.
5288 MESSAGE Could not create output spoolfile directory
symbol table.
5289 MESSAGE Could not create a virtual object to hold
output spoolfile queue entries.
5290 MESSAGE Could not create output spoolfile queue head
symbol table.
5291 MESSAGE Could not re-open a spoolfile already opened
by the current process.
5292 MESSAGE Could not gain access to the label of a file
already opened by the current process.
5293 MESSAGE FCLOSE of a spoolfile failed.
5294 MESSAGE Read or write of a spoolfile's label
extension failed.
5295 MESSAGE Spoolfile does not exist on any of the
volumes currently mounted.
5296 MESSAGE Low-level open of spoolfile failed due to
file descriptor allocation limitations.
5297 MESSAGE System error performing low-level open of
spoolfile.
5298 MESSAGE The spoolfile was still in the CREATE state
when the system was interrupted. It could not
be recovered, and has been deleted.
5299 MESSAGE Infinite loop corruption detected in output
spoolfile directory. Reboot your system to
rebuild the directory. If the problem recurs,