MPE/iX Error Messages Manual Vol 2 (32650-90902)

526 Chapter12
Store/Restore (Native Mode) and TurboSTORE/iX III
(S/R) cont.
NONE OF THE DEVICES SHOULD BE DDS UNITS (S/R
2255)
CAUSE Both 1/2 inch and DDS devices were specified for a store
command.
ACTION Make sure all file equations reference the same type of
devices and reissue the store command.
2259 MESSAGE SET INFORMATION AREA OF DIRECTORY EXTENSION
MISSING
CAUSE No parallel store set information was written to this tape.
ACTION Contact your HP representative.
2263 MESSAGE THE MEDIA ON LDEV ! WAS CREATED WITH DEVICE
HARDWARE COMPRESSION. THIS MEDIA CAN NOT BE
RESTORED WITH THE CURRENT DRIVE. IF THE
DEVICE IS AN 7980XC THEN TURN ON THE DEVICE
COMPRESSION FEATURE AND RETRY. (S/R 2263)
CAUSE You are trying to restore from a hardware compressed tape
with a non-compression drive.
ACTION If possible, enable compression on your drive. Alternately,
restore this tape with a device capable of reading a
hardware-compressed tape.
2265 MESSAGE OPEN ERROR WHILE REMAPPING THE BACKUP FILE ON
LDEV ! (S/R 2265)
CAUSE STORE encountered an error while closing the specified
magneto-optical device.
ACTION Contact your HP representative.
2266 MESSAGE MAPIN ERROR WHILE REMAPPING THE BACKUP FILE
ON LDEV ! (S/R 2266)
CAUSE STORE encountered an error while closing the specified
magneto-optical device.
ACTION Contact your HP representative.
2267 MESSAGE CLOSE ERROR WHILE REMAPPING THE BACKUP FILE
ON LDEV ! (S/R 2267)
CAUSE STORE encountered an error while closing the specified
magneto-optical device.
ACTION Contact your HP representative.
2268 MESSAGE THE VOLUME SET NAME ! MOUNTED ON LDEV ! IS
GREATER THAN 8 CHARACTERS. ONLY FIRST 8
CHARACTERS WILL BE USED TO CONSTRUCT THE
BACKUP FILE NAME (S/R 2268)
CAUSE Store/Restore will only use the first 8 characters of the