MPE/iX Error Messages Manual Vol 2 (32650-90902)

Chapter 10 417
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
413 MESSAGE EXPECTED 'HIGH={datasetnumber}' WHERE
{datasetnumber} IS A
POSITIVE INTEGER DENOTING A DATA SET BETWEEN
0 AND 199. SYNTAX
'HIGH={datasetnumber}' (S/R 413)
CAUSE You did not type the high parameter correctly.
ACTION Check the syntax and retype the command.
414 MESSAGE EXPECTED {datasetnumber} BETWEEN 0 AND 199.
SYNTAX
'HIGH={datasetnumber}' (S/R 414)
CAUSE You did not specify a number within the range.
ACTION Specify a number between 1 and 199.
415 MESSAGE {datasetnumber} SPECIFIED FOR 'HIGH' OPTION
MUST BE GREATER THAN OR EQUAL TO THE VALUE
SPECIFIED FOR THE 'LOW' OPTION. SYNTAX
'HIGH={datasetnumber}' (S/R 415)
CAUSE The high parameter is too small.
ACTION Specify a larger number for the high parameter.
421 MESSAGE WARNING: 'LOW' OPTION HAS BEEN REDUNDANTLY
SPECIFIED (S/R 421)
CAUSE The LOW option was entered more than once.
ACTION Information only.
422 MESSAGE EXPECTED '={datasetnumber}' AFTER 'LOW'
OPTION. SYNTAX
'LOW={datasetnumber}' (S/R 422)
CAUSE You did not specify datasetnumber.
ACTION Check the syntax and retype the command.
423 MESSAGE EXPECTED 'LOW={datasetnumber}' WHERE
{datasetnumber} IS A POSITIVE INTEGER
DENOTING A DATA SET BETWEEN 0 AND 199. SYNTAX
'LOW={datasetnumber}' (S/R 423)
CAUSE You did not specify a number within the range.
ACTION Specify a number between 1 and 199.
424 MESSAGE {datasetnumber} SPECIFIED FOR 'LOW' OPTION
MUST BE LESS THAN OR EQUAL TO THE VALUE
SPECIFIED FOR THE 'HIGH' OPTION. SYNTAX