MPE/iX Error Messages Manual Vol 2 (32650-90902)

Chapter 10 409
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
CAUSE The PROGRESS option was entered more than once.
ACTION Information only.
322 MESSAGE EXPECTED {#minutes} BETWEEN 1 AND 60. SYNTAX
PROGRESS[={#minutes}] (S/R 322)
CAUSE You did not specify a number within the range.
ACTION Specify a number between 1 and 60.
323 MESSAGE EXPECTED 'PROGRESS={#minutes}' WHERE
{#minutes} IS A POSITIVE INTEGER. (S/R 323)
CAUSE The progress parameter must be greater than zero.
ACTION Check your syntax and retype the command.
324 MESSAGE EXPTECTED '={#minutes}' AFTER 'PROGRESS'
OPTION. (S/R 324)
CAUSE You did not type the progress parameter correctly.
ACTION Check the syntax and retype the command.
331 MESSAGE 'STORESET' OPTION CANNOT BE USED WITH
'TRANSPORT' TO MPEv. (S/R 331)
CAUSE You cannot specify the storeset and transport parameters
on the same command line.
ACTION Delete either the storeset or the transport parameter from
the command line.
332 MESSAGE 'STORESET' OPTION HAS BEEN REDUNDANTLY
SPECIFIED. (S/R 332)
CAUSE You entered STORESET twice in the command.
ACTION Delete one of the STORESET options and retype the
command.
333 MESSAGE 'STORESET' OPTION MAY NOT BE SPECIFIED IN
CONJUNCTION WITH A POSITIONAL DEVICE FILE. EG
'STORE...;*t;STORESET=(*t1,*t2)' IS VALID.
(S/R 333)
CAUSE You mistyped the storeset parameter.
ACTION Check the syntax of the storeset parameter and retype the
command.
334 MESSAGE EXPECTED '=(device[,,..])[,(device[,...])]'
AFTER 'STORESET' OPTION. SYNTAX
'STORESET=(device[,..])[,(device[,...])]'
(S/R 334)
CAUSE You did not type the storeset parameter correctly.