MPE/iX Error Messages Manual Vol 2 (32650-90902)

382 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
command.
1003 MESSAGE **error** Can't read file label of file !
CAUSE This is caused by an I/O error.
1004 MESSAGE **error** No disc ipl boot file--Can't make
tape.
CAUSE Through deletion or modification, no boot image is
designated as the ISC IPL file. The system requires that
both a disk and a tape IPL file be present.
ACTION As the original file should still exist in the proper account,
add the image and file name to SYSFILEP through the
SYSFILE configurator command ABOOT. Retry the TAPE
command.
1005 MESSAGE **error** No tape ipl boot file--Can't make
tape.
CAUSE Through deletion or modification, no boot image is
designated as the tape IPL file. The system requires that
both a disk and a tape IPL file be present.
ACTION As the original file should still exist in the proper account,
add the image and file name to SYSFILEP through the
SYSFILE configurator command ABOOT. Retry the TAPE
command.
1006 MESSAGE **error** records of file ! too long for
SYSGEN
CAUSE The tape block size is greater than the size required by
SYSGEN (currently 16 K).
ACTION Decrease the block size in the file.
1007 MESSAGE **error** The tape boot files must fit on 1
tape.
CAUSE All files of type (tapeboot, tapeauto,tapeipl) as well as type
both (bothboot, botauto, bothipl) must fit on one reel.
ACTION Use a tape of sufficient size, and delete unnecessary or
outdated boot files through the SYSFILE configurator
DBOOT command.
1008 MESSAGE Ran out of tape while dumping file: !
CAUSE Same as above.
1009 MESSAGE **error** Couldn't write eof mark on tape
CAUSE A hardware failure occurs on the drive.
ACTION Check that the tape is good and that it has been mounted
properly. Replace the tape if necessary and try again. If
failure occurs, the problem is more than likely with the