MPE/iX Error Messages Manual Vol 2 (32650-90902)

Chapter 9 379
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
CAUSE The numeric value you enter for the parameter exceeds
the maximum permissible value.
ACTION Use the SHOW command to display minimum and
maximum parameter values. Enter a value within the
range.
0032 MESSAGE **error** parameter value too small
CAUSE The numeric value you enter for the parameter is less
than the minimum perimissible value.
ACTION Use the SHOW command to display minimum and
maximum parameter values. Enter a value within the
range.
0033 MESSAGE **error** parameter name must start with an
alphabetic
CAUSE The parameter requires a string value that begins with an
alphabetic character. The value starts with a number.
ACTION Enter a valid name beginning with an alphabetic
character.
0034 MESSAGE **error** parameter name contains illegal
character
0035 MESSAGE (bus converter # : min=1, max=2)
Boot Tape Messages
0001 MESSAGE **error** can't open boottype
CAUSE The TAPE command has been issued but SYSGEN cannot
generate a boot tape.
ACTION Check to see the tape is unlabeled, not specially formatted,
and of proper density. check prior file equations for TAPE
commands. Check to be sure the tape is not damaged.
0013 MESSAGE **error** fail to write boottape label
CAUSE The tape does not meet SYSGEN requirements; the TAPE
command cannot properly format the tape.
ACTION Check to see the tape is unlabeled, not specially formatted,
and of proper density. check prior file equations for TAPE
commands. Check to be sure the tape is not damaged.
0015 MESSAGE **error** error write file ! onto boottape
CAUSE A file designated in SYSFILEP does not exist, is corrupted,
or there may be a tape problem.
ACTION check system program files through the SYSFILE
configurator SHOW command for spelling and duplication.
Cross-check suspect files through the command