MPE/iX Error Messages Manual Vol 2 (32650-90902)

340 Chapter9
System Startup, Shutdown, and Configuration (cont)
"Nonclass" Errors
too long to fit into SYSGEN's I/O display format.
ACTION Contact your software personnel responsible for
maintaining system files.
0419 MESSAGE **warning** Class ! already exists
CAUSE User is trying to add class !, and it already exists.
ACTION To modify an existing class, use the MCLASS command.
0420 MESSAGE **warning** Class ! already exists--class
mode ignored
CAUSE When adding a device with ADEV, the mode of the class(es)
specified may be given with the CMODE parameter;
however, it is ignored if the class already exists.
ACTION Enter the LCLASS command to verify that the class exists
and to verify that LDEVs are associated with the class
name.
0421 MESSAGE **warning** level parameter ignored-path
parameter used instead.
CAUSE If both the LEVEL= and PATH= parameters are given in the
LPATH command, only the PATH= parameter is used to
determine that path to list.
ACTION None required.
0422 MESSAGE **warning** mgrname parameter ignored--path
parameter used instead.
CAUSE If both the MGR= and PATH= parameters are given in the
LPATH command, only the PATH= parameter is used to
determine that path to list.
ACTION None required.
0425 MESSAGE **warning** The correct delimiter at this
level is a "!"
CAUSE In specifying a path, all bus converters must be followed
by a "/", while all other devices and adapters must be
followed with a ".". SYSGEN knows what the appropriate
delimiter is, and warns the user.
ACTION None required. SYSGEN replaces the incorrect delimiter.
0426 MESSAGE Path (up to this level) changed to !
CAUSE Issued with previous to indicate what the correct path is.
ACTION None required. SYSGEN has replaced the incorrect
delimiter.
0430 MESSAGE **warning** iopath ! (from DCC) does not
exist