MPE/iX Error Messages Manual Vol 2 (32650-90902)

Chapter 7 253
Volume II Chapter 5
VolumeManagement
VolumeManagement
(Subsystem 163)
NOTE This chapter includes HPVOLINFO error messages.
150 MESSAGE HPVOLINFO DETECTED AN INVALID ITEM
NUMBER.(VLMERR 150)
CAUSE One or more of the item numbers passed to HPVOLINFO
was not a valid item number for the intrinsic.
ACTION Check the item numbers being passed to HPVOLINFO
against the numbers in the discussion for HPVOLINFO in
the MPE/iX Intrinsics Reference Manual (32650-90028).
Make the call to HPVOLINFO with item numbers that
appear in the discussion for HPVOLINFO;.
151 MESSAGE HPVOLINFO DETECTED AN UNPAIRED ITEM
NUMBER/ITEM PARAMETER.(VLMERR 151)
CAUSE HPVOLINFO was called with either an item number
without a corresponding item, or an item without a
corresponding item number.
ACTION Check the call to HPVOLINFO, making sure the item
numbers and items are paired. Note: It is important that
an item number be followed immediately by it's item.
152 MESSAGE HPVOLINFO REQUIRES AN ADDITIONAL
PARAMETER.(VLMERR 152)
CAUSE HPVOLINFO was called with a volume specifier number
that was not 0; volume specifier numbers that are not 0
require a volume specifier to be supplied.
ACTION Call HPVOLINFO with a volume specifier when the
volume specifier number being used is not 0.
153 MESSAGE HPVOLINFO RECEIVED A PARAMETER WITH AN
INVALID ADDRESS.(VLMERR 153)
CAUSE Either the status parameter or one (or more) of the item
parameters being supplied to HPVOLINFO contains an
address that is not accessible by the user.
ACTION Make sure that the status parameter and the item
parameters are local to the code calling HPVOLINFO.
154 MESSAGE HPVOLINFO CALLED WHILE IN SPLIT STACK
MODE.(VLMERR 154)
CAUSE HPVOLINFO was called while the user program was in