MPE/iX Error Messages Manual Vol 2 (32650-90902)

Chapter 7 229
Volume II Chapter 5
UPS
ACTION Locate and correct the cause of the AC power failure. If AC
power is not restored within the next two minutes, the
UPS battery will be exhausted and the UPS output AC
power will fail, causing power loss to the computer
equipment.
41 MESSAGE UPS LDEV ! reports AC output power turned
off. (UPSERR 0041)
CAUSE The specified UPS device has turned off its AC output
power. Someone may have mistakenly turned off the UPS'
power switch, or the UPS may have malfunctioned.
Whatever equipment was receiving power from the UPS
has now lost power.
ACTION Investigate and correct the problem at the UPS. Turn on
all power control switches on the UPS. If the computer
(CPU) lost power, you will have to re-boot the system after
restoring the UPS power.
128 MESSAGE UPS LDEV ! reports UPS "System Fail"
condition cleared. (UPSWRN 0128)
CAUSE Some time ago, the specified UPS device had reported a
UPS "System Failure" condition. Now, the "System
Failure" condition within the UPS device has been
corrected and the UPS is reporting that it has returned to
normal operation.
ACTION No action is needed. This message merely confirms that a
previously reported problem has been corrected.
129 MESSAGE UPS LDEV ! reports UPS "Inverter Fail"
condition cleared. (UPSWRN 0129)
CAUSE Some time ago, the specified UPS device had reported a
UPS "Inverter Failure" condition. Now, the "Inverter
Failure" condition within the UPS device has been
corrected and the UPS is reporting a return to normal
operation.
ACTION No action is needed. This message merely confirms that a
previously reported problem has been corrected.
130 MESSAGE UPS LDEV ! reports UPS "Battery Not Present"
condition cleared. (UPSWRN 0130)
CAUSE Some time ago, the specified UPS device had reported a
"Battery Not Present" condition. Now, the "Battery Not
Present" condition within the UPS has been corrected and
the UPS is reporting that it has returned to normal
operation.
ACTION No action is needed. This message merely confirms that a
previously reported problem has been corrected.