MPE/iX Error Messages Manual Vol 2 (32650-90902)

142 Chapter4
Volume II Chapter 4
System Aborts
bit error could not be put on the unuseable_list.
1205 MESSAGE Some critical code locations could not be
modified.
1206 MESSAGE A call to pdc_model to get processor version
information failed.
1207 MESSAGE pdc would occupy greater than 4 mb in memory.
1208 MESSAGE The black hole page is in high memory, > 4gb.
1209 MESSAGE Bad data received from pdc_pat_mem.
1210 MESSAGE build_mm_osinfo received bad status from
allocate_osinfo_entry.
1300 MESSAGE The procedure CREATE_PROCESS_SWITCH_OBJ is
unable to create process SWITCH OBJECT.
CAUSE Unable to create an object for the CM procedure name to
the plabel table.
1301 MESSAGE The procedure CREATE_PROCESS_SWITCH_OBJ is
unable to create HASH TABLE.
CAUSE Unable to create the CM procedure name to the plabel
table.
1302 MESSAGE The procedure ALLOCATE_CM_PROCEDURE received
bad status from SWITCH_TO_CM.
CAUSE SWITCH_TO_CM could not call LOADPROC.
1303 MESSAGE The procedure DEALLOCATE_CM_PROCEDURE
received bad status from SWITCH_TO_CM.
CAUSE SWITCH_TO_CM could not call UNLAODPROC.
1304 MESSAGE The procedure DELETE_SCM_HASH_ENTRY failed to
find entry.
CAUSE Could not find a name in the CM procedure name to plabel
table.
1305 MESSAGE The procedure DELETE_SCM_HASH_ENTRY received
bad status from RELEASE_TABLE_ENTRY.
CAUSE A table management error occured while releasing a table
entry in the CM procedure to the plabel table.
1306 MESSAGE The procedure GET_PROCESS_SCM_PLABEL received
bad status from RELEASE_TABLE_ENTRY.
CAUSE A table management error occured while releasing a table
entry in the CM procedure name to the plabel table.
1307 MESSAGE The procedure SWITCH_TO_CM received bad
status from RELDATSEG.
CAUSE Unable to release a data segment previously created in