MPE/iX Error Messages Manual Vol 2 (32650-90879)

436 Chapter10
Store/Restore (Native Mode) and TurboSTORE/iX I
(S/R)
CAUSE SPLITVS and TRANSPORT options are not allowed on
the same command line.
ACTION Delete SPLITVS or TRANSPORT option and retype the
command.
702 MESSAGE WARNING: 'SPLITVS' OPTION HAS BEEN
REDUNDANTLY SPECIFIED (S/R 702)
CAUSE The SPLITVS option was entered more than once.
ACTION Information only.
703 MESSAGE EXPECTED '=volumesetname[,volumesetname...]'
AFTER 'SPLITVS' OPTION SYNTAX
'SPLITVS=volumesetname[,volumesetname...]'
(S/R 703)
CAUSE The '=' sign was left out after the SPLITVS option.
ACTION Retype the command and include the '=' sign after the
SPLITVS opti on.
704 MESSAGE INVALID VOLUMESET NAME SPECIFIED FOR
'SPLITVS' OPTION. VOLUMESET NAME MUST START
WITH AN ALPHA "A-Z" AND CONTAIN ONLY
ALPHANUMERIC "A-Z, 0-9", "_" AND "." SYNTAX
'SPLITVS=volumesetname[,volumesetname...]'
(S/R 704)
CAUSE The volumeset name specified for SPLITVS is invalid.
ACTION Retype the command and include a valid volumeset name.
705 MESSAGE VOLUMESET NAME SPECIFIED FOR 'SPLITVS' OPTION
EXCEEDED THE MAXIMUM ALLOWABLE LENGTH OF 32
CHARACTERS. SYNTAX
'SPLITVS=volumesetname[,volumesetname...]'
(S/R 705)
CAUSE The volumeset name specified for SPLITVS option
includes more than 32 characters.
ACTION Retype the command and make sure the volumeset name
includes 32 characters or less.
706 MESSAGE EXPECTED 'volumesetname[,volumesetname...]'
AFTER 'SPLITVS=' WHERE volumesetname IS THE
NAME OF A VOLUME SET THAT IS CURRENTLY
MOUNTED IN A SPLIT STATE ON YOUR SYSTEM.
SYNTAX
'SPLITVS=volumesetname[,volumesetname...]'
(S/R 706)
CAUSE You have not entered a mounted volumesetname for
SPLITVS option.
ACTION Retype the command and include a mounted