MPE/iX Error Messages Manual Vol 2 (32650-90879)
230 Chapter7
Volume II Chapter 5
UPS
UPS "Low Output Voltage Shutdown" condition. Now, the
"Low Output Voltage Shutdown" condition has been
corrected and the UPS is reporting a return to normal
operation.
ACTION No action is needed. This message merely confirms that a
previously reported problem has been corrected.
192 MESSAGE UPS LDEV ! reports UPS "System Fail"
condition. (UPSERR 0192)
CAUSE The specified UPS device reported a UPS "System Failure"
condition. This is a hardware malfunction condition within
the UPS.
ACTION Call your Hewlett-Packard service representative.
193 MESSAGE UPS LDEV ! reports UPS "Inverter Fail"
condition. (UPSERR 0193)
CAUSE The specified UPS device reported a "UPS Inverter Fail"
condition. This is a hardware malfunction condition within
the UPS. The DC-to-AC power inverter within the UPS
has malfunctioned.
ACTION Call your Hewlett-Packard service representative.
194 MESSAGE UPS LDEV ! reports UPS "Battery Not Present"
condition. (UPSERR 0194)
CAUSE The specified UPS device reported a "Battery Not Present"
condition. This is a hardware malfunction condition within
the UPS. The UPS hardware logic perceives that the UPS
battery pack is not connected.
ACTION Call your Hewlett-Packard service representative.
195 MESSAGE UPS LDEV ! reports UPS "Charger Fault"
condition. (UPSERR 0195)
CAUSE The specified UPS device reported a UPS "Charger Fault"
condition. This is a hardware malfunction condition within
the UPS. The UPS' internal battery charger circuitry has
malfunctioned.
ACTION Call your Hewlett-Packard service representative.
196 MESSAGE UPS LDEV ! reports UPS "Overload Shutdown"
condition. (UPSERR 0196) \CAUSE\ The specified
UPS device reported a UPS "Overload Shutdown"
condition. Too much power was being drawn from the UPS
AC output by the computer equipment being powered from
this UPS. That equipment may be malfunctioning.
ACTION Call your Hewlett-Packard service representative.
197 MESSAGE UPS LDEV ! reports UPS "High Ambient
Temperature Shutdown" condition. (UPSERR