MPE/iX Error Messages Manual Vol 2 (32650-90879)

130 Chapter4
Volume II Chapter 4
System Aborts
816 MESSAGE The procedure PUT_WAIT_QUEUE can not get a
free wait queue entry; bad status from
GET_TABLE ENTRY.
817 MESSAGE The procedure WAIT_FOR_RESOURCE detected that
interrupts are disabled when trying to block
the process for a control block.
818 MESSAGE The procedure WAIT_FOR_ACTIVE_PORT detected
that interrupts are disabled when trying to
block a process on the port wait.
819 MESSAGE The procedure WAIT_FOR_ACTIVE_PORT detected
that either the dispatcher was disabled, or
interrupts are off when awaken from an IPC
WAIT.
820 MESSAGE Various procedures are either returning a
port description that is already free,
obtaining a port description that has already
been assigned, or accessing a port or port
description pointer.
821 MESSAGE Calling CB_SHR_LOCK or CB_SHR_UNLOCK, but the
lock type is not valid.
822 MESSAGE An attempt was made to perform a CM_PENABLE
when the CM_PSDB semaphore was not owned by
any process.
823 MESSAGE An attempt was made to perform a CM_PENABLE
when the CM_PSDB semaphore was owned by
another process.
824 MESSAGE An attempt was made to perform a CM_PDISABLE,
but the count overflowed. The process has
locked the CM_PSDB semaphore too many times
(it is a 16-bit counter).
825 MESSAGE Unknown error while accessing CM_PSDB
semaphore.
900 MESSAGE The CREATE of the HLIO SANCTUM failed.
CAUSE HLIO SANCTUM could not be created.
901 MESSAGE The CREATE of the COMPATIBILITY MODE I/O
queue failed.
CAUSE COMPATIBILITY MODE I/O queue could not be created.
902 MESSAGE The CREATE of the COMPATIBILITY MODE I/O
STATE TABLE failed.
CAUSE COMPATIBILITY MODE I/O STATE TABLE could not be
created.
903 MESSAGE The CREATE of the LOGICAL PATH TABLE failed.