MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 99
Command Interpreter
(CIERR)
(CIWARN 1041)
CAUSE The DEV option was specified more than once.
ACTION None. Information only. The last DEV option specified is
the one used.
1042 MESSAGE EXPECTED "DEV= [DEVICE NAME]". (CIERR 1042)
CAUSE The DEV option was omitted.
ACTION Reenter the command making sure the DEV= option is
specified.
1043 MESSAGE EXPECTED DEVICE NAME AFTER "DEV=". (CIERR
1043)
CAUSE The DEV= option was specified without a device name.
ACTION Reenter the command making sure a device name is
specified.
1044 MESSAGE DEVICE NAME IS MORE THAN 8 CHARACTERS LONG.
(CIERR 1044)
CAUSE The device name specified with the DEV= option exceeds
eight characters.
ACTION Reenter the command making sure the device name is less
than or equal to eight charaters.
1045 MESSAGE EMBEDDED NON-ALPHANUMERIC CHARACTER IN DEVICE
ID. (CIERR 1045)
CAUSE Syntax error.
ACTION Reenter the command making sure a valid device name is
specified.
1046 MESSAGE NOT ENOUGH STACK SPACE AVAILABLE FOR RESTORE.
(CIERR 1046)
CAUSE Same as the message.
ACTION Alter the RESTORE file set or try to use the :RUN
RESTORE command. Refer to a system utility manual for
more information.
1047 MESSAGE FOPTIONS ON TAPE WRONG - SHOULD BE NOCCTL,
UNDEFINED RECORD FORMAT, BINARY, NEW. (CIERR
1047)
CAUSE Syntax error.
ACTION Check the syntax and reenter the command.
1048 MESSAGE AOPTIONS ON TAPE WRONG - SHOULD BE WAIT,
EXCLUSIVE, NO MULTIRECORD, READ ONLY. (CIERR
1048)
CAUSE Syntax error.