MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 43
Command Interpreter
(CIERR)
ENV parameter in your file equation.
ACTION Check for syntax or spelling errors and reenter the
command. To review the command syntax, invoke the
online Help Facility or refer to the MPE/iX Commands
Reference Manual.
334 MESSAGE "DEN" PARAMETER OVERRIDES PREVIOUS "DEN"
PARAMETER. (CIWARN 334)
CAUSE You have included more than one DEN parameter in your
command line; the system is warning you that it is using
the last one named.
ACTION If you do not wish the system to use the last one named in
your command line, reenter the command, omitting the
redundancy.
335 MESSAGE "DEN" HAS ONLY ONE PARAMETER, THE DENSITY.
(CIERR 335)
CAUSE You have entered something that the system does not
recognize in your DEN parameter. You can only specify
one value, the density, in this parameter.
ACTION Check for syntax or spelling errors and reenter the
command. For more information about the command
syntax, invoke the online Help facility or refer to the
MPE/iX Commands Reference Manual.
336 MESSAGE DENSITY MUST BE 800, 1600 OR 6250. (CIERR
336)
CAUSE You have entered an unacceptable value for the density
parameter. Only 800, 1600, or 6250 is allowed.
ACTION Check for syntax or spelling errors and reenter the
command. For more information about the command
syntax, invoke the online Help Facility or refer to the
MPE/iX Commands Reference Manual.
337 MESSAGE EXPECTED BALANCING QUOTE TO TERMINATE STRING.
(CIERR 337)
CAUSE You opened your string with a quotation mark (' or ") but
failed to close the string with one.
ACTION Reenter the command; remember to use an opening and a
closing quote around the character string.
338 MESSAGE VOLID CONTAINS NONPRINTABLE CHARACTER. (CIERR
338)
CAUSE You have entered something that the system does not
recognize in the VOLID parameter. You may have pressed
a special key, such as the ESCape key, by accident.
ACTION Reenter the command; take care not to press any special