MPE/iX Error Messages Manual Vol 1 (32650-90878)

328 Chapter4
Error Messages V i C 4
(Subsystem 121)
244 MESSAGE The error bit in the CS80 hardware status is
set, which indicates that a HARDWARE FAULT
occurred in the addressed unit of the device.
CAUSE Could be hardware problem, or a transient problem due to
power-on.
ACTION Call your support representative.
245 MESSAGE The error bit in the CS80 hardware status was
set, which indicates that a HARDWARE FAULT
occurred in the device controller.
CAUSE Device hardware problem.
ACTION Call your support representative.
246 MESSAGE The error bit in the CS80 hardware status was
set, which indicates that an error occurred
during a transfer of data between 2 units in
the device (COPY DATA CS80 Command only).
CAUSE This should never occur as this feature is not supported.
ACTION Call your support representative.
247 MESSAGE The error bit in the CS80 hardware status was
set, which indicates the execution phase
length is not as expected. A REJECT error
occurred; could be cabling.
CAUSE CS80 transaction was incorrect; could be cabling.
ACTION Verify that cabling is correct and call your support
representative.
248 MESSAGE The error bit in the CS80 hardware status was
set, which indicates that the CS80 Command
bytes were out-of-sequence. A REJECT error
occurred; could be cabling.
CAUSE CS80 transaction was incorrect; could be cabling.
ACTION Verify that cabling is correct and call your support
representative.
249 MESSAGE The error bit in the CS80 hardware status was
set, which indicates that the parameter field
of the CS80 Command is invalid. A REJECT
error occurred; could be cabling.
CAUSE CS80 transaction was incorrect.
ACTION Verify that cabling is correct and call your support
representative.
250 MESSAGE The error bit in the CS80 hardware status was
set, which indicates that the value in the
PARAMETERS of the CS80 Command is too large.