MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 4 319
Error Messages V i C 4
(Subsystem 121)
was already granted.
ACTION None.
7 MESSAGE A bit in the CS80 Hardware status information
field was set for which there is no value
defined.
CAUSE Device returned an undefined Warning/Info status.
ACTION Call your support representative.
8 MESSAGE The device missed a revolution during this
transfer.
CAUSE Occurs normally on occasion.
ACTION None.
9 MESSAGE The bit in the CS80 hardware status was set,
which indicates that the logs on the device
are full.
CAUSE Error logs in the device are full.
ACTION Call your support representative.
10 MESSAGE The bit in the CS80 hardware status was set,
which indicates that the data in this
transfer was corrected by the device.
CAUSE Data was recovered with little difficulty.
ACTION None.
11 MESSAGE The bit in the CS80 hardware status was set,
which indicates that the data was corrected
by the device with difficulty.
CAUSE Data was recovered, but sector should be spared.
ACTION Call your support representative.
12 MESSAGE The bit in the CS80 Hardware status was set,
which indicates that the data was corrected
in more than one sector during this transfer.
The sector number in the error log is of the
first corrected one, only.
CAUSE Data was recovered, but sectors should be spared.
ACTION Call your support representative.
13 MESSAGE The bit in the CS80 hardware status was set,
indicating that a defective sector was
AUTOMATICALLY SPARED by the device.
CAUSE Device performed automatic sparing. Data was recovered.
ACTION None.