MPE/iX Error Messages Manual Vol 1 (32650-90878)

312 Chapter3
Command Interpreter
(CIERR) 1901-12256
ACTION Re-enter the command. Submit a bug report.
11061 MESSAGE One or more variables not shown. Job may have
terminated. (CIERR 11061)
CAUSE The most likely cause is that the target job/session
terminated, and thus the variable could not be retrieved
from that job/session.
ACTION Execute the SHOWJOB command to verify the existence
of the target job/session. Re-enter the SHOWVAR
command if appropriate.
11701 MESSAGE The NOW option requires SM capability. (CIERR
11701)
CAUSE The SETCLOCK command was issued with the ;NOW
option but without the user having SM capability.
ACTION Issue the SETCLOCK command without the ;NOW option,
or issue the command after obtaining SM capability.
11702 MESSAGE SETCLOCK requires DATE and TIME, CORRECTION,
or TIMEZONE. (CIERR 11702)
CAUSE The SETCLOCK command was issued with none of the
required parameters.
ACTION Issue this command with a DATE and TIME,
CORRECTION, or TIMEZONE parameter.
11703 MESSAGE Both DATE and TIME parameters must be
supplied. (CIERR 11703)
CAUSE The DATE or TIME parameter was provided without also
providing the other parameter. The SETCLOCK command
requires both parameters to uniquely define a system
time.
ACTION Issue the command with both DATE and TIME
parameters.
11704 MESSAGE SETCLOCK requires DI in addition to either SM
or OP capability. (CIERR 11704)
CAUSE The SETCLOCK command was attempted without DI and
either SM or OP capability.
ACTION Issue the command with DI and either SM or OP
capability.
11705 MESSAGE The NOW or GRADUAL option requires both DATE
and TIME. (CIERR 11705)
CAUSE The SETCLOCK command's ;NOW or ;GRADUAL option
was used without also providing the DATE and TIME
parameters.
ACTION Issue the SETCLOCK command and provide DATE and