MPE/iX Error Messages Manual Vol 1 (32650-90878)

308 Chapter3
Command Interpreter
(CIERR) 1901-12256
sets an error occurred, and none of the volume sets will be
switched.
ACTION Perform a :DSTAT to make sure all the ldevs in the
indicated volume set are in "loner" or "locked" state on the
current system, and if possible the alternate system. Make
sure the ldevs are connected to both systems. Re-enter the
command.
10929 MESSAGE ONE OR MORE LDEVS IN VOLUME SET !volset name
ARE NOT RESPONDING. (CIWARN 10929)
CAUSE An :SPUCONTROL SETUP, :SWITCHBACK, or
:SWITCHOVER was entered. One of the LDEVS in the
indicated volume set was not responding. It may be
powered off. Since one or more of the LDEVS in the
volume set were not responding, none of the volume sets
could be switched.
ACTION Check of the LDEVS in the volume set. Make sure they
are powered on. Also check all of the connections to both
systems. Re-enter the command.
10932 MESSAGE VOLUME SET !volset name NOT CONNECTED TO THIS
SYSTEM. (CIWARN 10923)
CAUSE An :SPUCONTROL STATUS was entered, but the volume
set indicated in the message is not mounted on the current
system.
ACTION Do a SYSGEN SPU> SHOW to see the list of volume set
names. Perform a :DSTAT and compare the volume set
names to those in the configuration file. Check the disk
drive connections to the system.
10924 MESSAGE VOLUME SET !volset name IS NOT CLOSED ON
SYSTEM !sysname. (CIERR 10924)
CAUSE An :SPUCONTROL SETUP, :SWITCHBACK, or
:SWITCHOVER was entered, but the volume set indicated
in the message was not :VSCLOSEd on the system
indicated. Volume sets must be closed before being
switched between systems.
ACTION :VSCLOSE all volume sets that will be switched.
10925 MESSAGE NO VOLUME SETS SPECIFIED IN THE SPUSO
CONFIGURATION FILE. (CIWARN 10925)
CAUSE An :SPUCONTROL STATUS was entered, but there were
no volume sets specified in the configuration file.
ACTION If there were supposed to be volume sets listed, check the
SPUSO configuration by doing a SYSGEN SPU> SHOW.
10926 MESSAGE ALL VOLUME SETS HOME TO SYSTEM !sysname WERE