MPE/iX Error Messages Manual Vol 1 (32650-90878)

14 Chapter2
Command Interpreter
(CIERR)
(CIERR)
11 MESSAGE PROGRAMMATIC EXECUTION OF THIS COMMAND HAS
BEEN DISABLED. (CIERR 11)
CAUSE The command in question may not be executed
programatically.
ACTION See your system manager.
12 MESSAGE COMMAND NOT PROGRAMMATICALLY EXECUTABLE.
(CIERR 12)
CAUSE The command in question may not be executed
programatically.
ACTION There is no way at present to change this characteristic. If
you feel that this is something you need, you may wish to
inform your system manager or support representative.
13 MESSAGE COMMAND NOT TERMINATED BY CARRIAGE RETURN.
(CIERR 13)
CAUSE Somehow the system has attempted to execute your
command line without your having pressed the carriage
return key.
ACTION Reenter your command; be sure you press the return key
at the end of your command.
14 MESSAGE PARAMETER EXCEEDS 255 CHARACTERS. (CIERR 14)
CAUSE One of your command parameters contains more than 255
characters, which is the maximum allowed.
ACTION Reenter your command; be sure none of your parameters
exceeds 255 characters.
80 MESSAGE CAN'T INITIATE NEW SESSIONS NOW. (CIERR 80)
CAUSE This may mean that the maximum number of users are
currently logged on; or, it may mean that your system
management is doing something on the system that
requires all users to be logged off.
ACTION You can wait a while and try again later; if you get this
message again, contact your system operator for
assistance.
81 MESSAGE STACK TOO SMALL FOR STREAM COMMAND TO BEGIN
PROCESSING. (CIERR 81)
82 MESSAGE STREAM FACILITY NOT ENABLED: SEE OPERATOR.
(CIERR 82)
CAUSE Apparently your system management has disallowed the