MPE/iX Error Messages Manual Vol 1 (32650-90878)

Chapter 2 135
Command Interpreter
(CIERR)
1627 MESSAGE ! NOT INTERACTIVE; MESSAGE NOT SENT TO JOB
(CIWARN 1627).
CAUSE You cannot send a message to a job.
ACTION Only send messages to interactive sessions.
1628 MESSAGE LOGON DEVICE ACCESS SECURITY VIOLATION (CIERR
1628).
1630 MESSAGE TARGET FILE IS THE ONLY PARAMETER ALLOWED.
(CIERR 1630)
CAUSE The only valid parameter is the target file.
ACTION Specify a valid target file.
1631 MESSAGE TARGET FILE IS A REQUIRED PARAMETER. (CIERR
1631)
CAUSE The target file was not specified.
ACTION Specify a valid target file.
1632 MESSAGE UNABLE TO OPEN PERMANENT DISK FILE !. (CIERR
1632)
CAUSE Same as the message.
ACTION Contact your system manager to check for disk allocation.
1633 MESSAGE FILE SYSTEM ERROR ! WHILE READING PAPER TAPE.
(CIERR 1633)
CAUSE Same as the message.
ACTION Refer to the File System error message section.
1634 MESSAGE FILE SYSTEM ERROR ! WHILE WRITING TO DISK
FILE. (CIERR 1634)
CAUSE Same as the message.
ACTION Refer to the File System error message section.
1635 MESSAGE FILE SYSTEM ERROR ! WHILE CLOSING DISK FILE.
(CIERR 1635)
CAUSE Same as the message.
ACTION Refer to the File System error message section.
1636 MESSAGE UNABLE TO ACCESS PAPER TAPE READER ON
TERMINAL. (CIERR 1636)
CAUSE Same as the message.
1640 MESSAGE THE ONLY PARAMETERS ARE THE INPUT AND OUTPUT
SPEEDS. (CIERR 1640)
CAUSE Specifying parameters other than the input speed and
output speed is not allowed.