MPE/iX Commands Reference Manual (32650-90877)

Chapter 13 589
Command List XI
Commands SHOWLOG thru STORE
completion of the attach phase is also sent to the system console:
FILES LOCKED BY ONLINE STORE ARE NOW FREE FOR READ/WRITE/PURGE
See the NOTIFY option for an additional way to notify users that the attach
phase has completed.
START Specifies that a 7x24 true-online sync point should occur at the beginning
of the backup, before any files are stored. All files being stored do NOT
have to be closed for write access when the backup starts.
END Specifies that a 7x24 true-online sync point should occur at the end of the
backup, after all files are stored. All files being stored do NOT have to be
closed for write access at any time during the backup.
Specifying the option causes file log data to be written at the end of the
backup. This media format is NOT backwards compatible, and media
created with ONLINE=END CANNOT be verfied or restored on a pre-5.5
system.
time Specifies when the true-online sync point should occur, in in 24-hour
format, as HH:MM:SS.
The
time must be specified with either START or END. If specified with
START, the sync point will occur at the time specified, or after all of the files
being stored are attached to shadow log files, whichever happens last. If
specified with END, the sync point will occur at the time specified, or once
all files have been stored, whichever happens last.
If the time specified is before the time the backup is started, then STORE
will wait until that time the following day. This is helpful if you start the
backup at 11:00 PM and want the sync point to occur at 2:00 AM the next
morning.
ASK When specified, will cause TurboSTORE to pause with an operator request
before the true-online sync point. If you reply "N" to this request, you will
be given the option of aborting the backup or continuing to wait.
After you reply to the console request, the sync point will occur.
This option can be specified with
time , and must be specified with either
START or END.
volumesetname The name of the volume set where the shadow log files should reside,
which must be a valid, currently mounted volume set.
Operation Notes
• Usage
The STORE command stores one or more disk files onto magnetic tape DDS or MO disc.
It will store only those files whose home volume set(s) is (are) mounted.
• Required capabilities for storing files
If you have system manager (SM) or system supervisor (OP) capability, you can store
any file in the system. If you have account manager (AM) capability, you can store any