HP System Dictionary/XL General Reference Manual Vol 2 - Part 1 SDINIT (32256-90005)

C-143
D SDCONV Error Messages
The following is a complete list of SDCONV errors listed in order by error number. The list includes at
least one possible cause of each error and a recommended action for each cause.
NOTE Some of these messages list an action of "Refer to the associated error." With these
messages,SDCONV willdisplayanadditional messagerelatedtoa SystemDictionary
intrinsic, the MPE XL file system, the Pascal Run-Time Library, the Native Language
Subsystem, or TurboIMAGE. Refer to the documentation on these subsystems for ad-
ditional information on the problem.
Some of these messages list an action of "Notify the Dictionary Administrator." In this
case, SDCONV has encountered an error that requires the attention of the Dictionary
Administrator or System Manager. If the DA or System Manager needs assistance in
solving the problem, they should contact the Hewlett-Packard Response Center.
Some of the messages, as shown in this manual, include an exclamation point (!).
When the actual message is displayed, this substitution character will be replaced by
appropriate information, such as a file name or subsystem error number.
SDCONV Warning Messages (3501 - 3602)
3501 MESSAGE Logging disabled (SDWARN 3501)
CAUSE SDCONV will not log the user's commands, because it could not open SDLOG.
ACTION None necessary. If command logging is essential for you, exitthe program immediately, correct any problem,
and reinvoke theprogram.
3502 MESSAGE New log file ! is temporary. Save it for future use (SDWARN 3502)
CAUSE SDCONV is informing the user that the log file is temporary.
ACTION Save the log file if you want to keep it.
3503 MESSAGE Mapping does not exist. No delete done (SDWARN 3503)
CAUSE You used the MAP command to delete the mapping for a characterfor which no mapping was defined.
ACTION None necessary. If you mistyped the command, however, then usethe REDO command or retype it.
3504 MESSAGE Map table full. Mapping not inserted (SDWARN 3504)
CAUSE The map table already contained the maximum number of mappingsallowed before you tried to insert a new
mapping.
ACTION Display the map table and delete any mappings which are nolonger necessary. You can then insert the desired
mapping.
3505 MESSAGE Name too long truncated to ! (SDWARN 3505)
CAUSE Mapping the name according to the mappings specified in the maptable caused the length of the mapped name
to exceed the maximumname length.
Message Number Error Type
3501 - 3602 SDCONV Warning Messages
3603 - 3937 SDCONV Error Messages