HP SNMP/XL User's Guide (36922-90036)

Chapter 3 33
Using SNMPUTIL
SNMPCONTROL User Defined Command
Parameters
TRACE
This parameter is optional and specifies that you want
to start the subsystem with the internal trace facility
enabled. When this parameter is used, the tracing
remains active until the HP SNMP/XL subsystem is
stopped or the trace command is used to turn off
tracing. The tracing information is recorded in a file
named NMTCnnnn.PUB.SYS, where nnnn represents
numerically sequential trace files. This file name is the
default and is used unless the TFILE option is specified.
The default is no tracing.
TFILE-SIZE=filez_size
This parameter is optional and is ignored unless the
TRACE parameter is specified. It allows you to specify
the number of records in the SNMP/XL trace file as the
value of
file_size . The value should be a decimal
number specifying the trace file size in number of 128
word records.
The default is 1024.
TFILE=file_name
This parameter is optional and is ignored unless the
TRACE parameter is specified. It allows you to specify
the name of the trace file, instead of using the default
trace file name as the value of
file_name . File_name
must be a string of characters that define a valid MPE
file name.
OVERRIDE
This parameter is optional and allows you to override
HP SNMP/XL version inconsistencies which would
normally prevent successful activation of the HP
SNMP/XL subsystem. Use of this parameter requires
PM and DI capabilities in addition to the NM capability
required to issue the SNMPCONTROL command.
CAUTION The OVERRIDE parameter is intended for use by Hewlett-Packard
support engineers. Hewlett-Packard is not responsible for damages
resulting from unauthorized use.
SYSFAIL
This parameter is optional and allows you to produce a
system halt if an irrecoverable internal error occurs
within the SNMP/XL subsystem.