HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 4 67
Planning for Node Configuration
Node Worksheet Information
Use Auto-Negotiation 100Base-T Configuration Should the adapter attempt to
auto-negotiate with the hub/switch.
Use this feature ONLY if the
hub/switch supports this feature also.
Link Speed 100Base-T Configuration This is the desired speed at which link
should operate. Valid values are 10 or
100 MBit/sec. This fieldis only needed
if auto-negotiation is not used.
Full Duplex Mode 100Base-T Configuration Should full duplex mode be used. This
is based on the capability of the
hub/switch to which the adapter is
connected. This field is only needed if
auto-negotiation is not used.
Proxy node LAN Configuration The proxy field is optional. Enter Y
(yes) only if your network has
internetworks (networks with
gateways) or non-HP nodes.
Establishing a proxy node is a way of
placing node name and address
mapping information in a single
location. For more information, see
the configuration chapter for LAN
link.
Remote IP address X.25 Virtual Circuit
Configuration
In the network directory, the IP
address of each node listed in the
remote node name field.
Remote node name X.25 Virtual Circuit
Configuration
In the network directory, the name of
each remote X.25 node on the network
Remote X.25 address X.25 Virtual Circuit
Configuration
For SVCs only. In the network
directory, the X.25 address of the
remote host for X.25 public data
networks or private networks.
Field Screen Description