HP e3000/iX Network Planning and Configuration Guide (36922-90037)

234 AppendixD

NS X.25 Migration: NS 3000/V and NS 3000/XL Release 1.X to iX Release 2.0 or later

To Use NMMGRVER

7. On the screen with the path @NETXPORT.NI.niname.LINK.linkname,

answer yes or no; then, press the Update key.

To Save X.25 XL System Access Parameters on the

Host

Make a list of the following X.25 XL System Access Parameters on the

host that must be re-entered on the DTC.

• Local Node Name.

• Link Name (the X25 link, not the DTSLINK).

• DTC Node Name.

• DTC Card Number.

• X.25 User Facility Set Parameters.

To Add Other Link Types as Needed

For LAN and Point-to-Point link types, run NMMGR and add the

physical paths. See sections of this manual for the correct values to be

entered for the physical path.

To Verify DTS Conﬁguration on the Host

If the datacommunications and terminal subsystem (DTS) has not been

conﬁgured, conﬁgure the DTS parameters on the host according to the

requirements of your network. For more information, refer to Getting

Started with the DTC and Conﬁguring Systems for Terminals, Printers,

and Other Serial Devices if you are using PC-based network

management. Refer to Conﬁguring and Managing Host-Based X.25

Links if you are using host-based network management.