HP e3000/iX Network Planning and Configuration Guide (36922-90037)

182 Chapter13
Configuring Logging
To Modify the Logging Configuration
To Modify the Logging Configuration
The Netxport Log Configuration (1) screen (#61) in Figure 13-2 is
displayed when you press the
[Modify Logging] function key at the
Network Transport Configuration screen.
Figure 13-2 Netxport Log Configuration (1) Screen
Use the fields and the function keys of the screen to configure logging
for the subsystems represented on the screen. If the subsystem for
which you want to enable logging does not appear on the first screen,
press the
[Next Screen] function key to go to the next Netxport Log
Configuration screen. There are a total of six logging configuration
screens.
Enable or disable logging classes (or accept HP-recommended defaults).
Press the
[Save Data] key on each screen to create or modify the data
record. Verify that the data record has been created by checking that
the Data flag is Y.
Fields Console
Logging The value entered in this field specifies whether or not
logging events for the subsystem and class listed beside
the field will be logged to the system console. A value
must be entered for each subsystem and class listed. A
Y (yes) enables logging to the console, N (no) disables
logging to the console.