HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 10 159
Validating Network Transport and Cross-Validating with SYSGEN
To Cross-Validate in SYSGEN
To Cross-Validate in SYSGEN
Cross-validation ensures that there are no conflicts in the use of node
names, device classes, and physical paths between the data currently
contained in NMCONFIG.PUB.SYS and the system configuration data.
To cross-validate, use the SYSGEN facility (OP capability is required).
To use SYSGEN, type the following commands at the MPE prompt
(user input is bold):
sysgen sysgen> io
io> ld (optional)
io> exit
sysgen> exit
The optional ld (list devices) command allows you to verify the
NMMGR devices that are configured.
Cross-validation is done on the KEEP, TAPE, I/O, and RDCC commands
in SYSGEN. For more information, see System Startup, Configuration,
and Shutdown.
If you have completed the configuration process, proceed to Chapter 14,
“Operating the Network.”