HP e3000/iX Network Planning and Configuration Guide (36922-90037)

134 Chapter7

Conﬁguring a Point-to-Point Node

To Conﬁgure Node Mapping

D Three-second delay (used for European

modems and automatic call units that

require built-in delays).

# Deﬁned by local phone system.

* Deﬁned by local phone system.

To disable outbound dialing, enter an exclamation point

(!) by itself in the phone number ﬁeld.

Each router NI can have up to 1024 mappings.

However, 4096 is the absolute maximum number of

unique phone numbers supported per NMCONFIG File.

Security

String An optional security string that remote nodes must use

to gain dial link access to the node. It can be up to eight

alphanumeric characters, left justiﬁed, with no

embedded blanks. The ﬁrst character must be

alphabetic.

Disable Route

Y (yes) or N (no) indicator that allows you to temporarily

disable a conﬁgured route. Leave the default (N) alone if

you do not want to disable the route.

To Conﬁgure Direct Connect/Dial Node Mapping

The Direct Connect/Dial Node Mapping Conﬁguration screen (#45) in

Figure 7-6 is displayed if you press the

[Link Routing] key at the

Point-to-Point Link Conﬁguration screen (#44) for a link of type DD or

DC.