HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 6 109
Configuring a LAN, Token Ring, FDDI, 100VG-AnyLAN, 100Base-T Node
To Configure a 100Base-T Network Interface
To Configure a 100Base-T Network
Interface
The 100Base-T Configuration screen (#297) in Figure 6-6 is displayed
when you press the
[Config Network] key at the Network Transport
Configuration screen (#42) with an NI type of 9 (100Base-T). Refer to
Chapter 5, “Introductory Screens,” for information on the Network
Transport Configuration screen.
Figure 6-6 100Base-T Configuration Screen
Step 1. In the IP address field, enter the internet protocol (IP) address for the
node being configured. An example of an address is:
C 192.191.191 009.
Step 2. The IP subnet mask is optional. If entering one, tab to the IP subnet
mask field and enter the number in the same format as an IP address.
Step 3. The proxy node is optional. Enter Y only if your network has
internetworks (networks with gateways) or non-HP nodes and you are
not using domain name services.
Step 4. Move to the Link name field. Enter a link name to represent the LAN
card for which you are configuring a link. This name must be unique to
the node.
Step 5. Tab down to the field called Physical path of device adapter.