HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 6 107
Configuring a LAN, Token Ring, FDDI, 100VG-AnyLAN, 100Base-T Node
To Configure a 100VG-AnyLAN Network Interface
For Class C, the node portion of the IP address must be between 001
and 254.
If you are adding your NS 3000/iX node to an existing network, the
network portion of each node’s IP address should be the same. You will
have to find out what this is, and use it in the network portion of the IP
address of your NS 3000/iX node. Also, you will need to know the node
portions of the IP addresses of each of the nodes (usually they will be
numbered sequentially, such as 001, 002, and so on), so that you can
specify a unique node portion for the IP address of your node. If you
have a network map, it should provide a record of such items as the
node name and IP address of each node. If there is no record, and if you
want to find out each node’s IP address, you will have to issue the
following command (NM capability required) on each of the nodes:
NETCONTROL NET=NIname;STATUS
One of the lines of output from this command tells you what the
complete IP address is for that node; the last three digits are the unique
node portion of the class C address.
NOTE To obtain a class B or C IP address, contact Government Systems,
Incorporated (GSI). To obtain an application form, write GSI at the
address below. Allow at least eight working days for GSI to process an
IP address request.
Government Systems, Inc.
Attn: Network Information Center
7990 Boeing Ct.
Vienna, VA 22183
[phone] [phone]
IP subnet
mask An IP subnet mask is specified in the same format as
an IP address. The 32-bit mask is grouped in octets
expressed as decimal integers and delimited by either a
period (.) or a space. An IP mask is used when
configuring subnetworks. The mask identifies which
bits of an IP address will be used to define a
subnetwork. To determine these bits, you first need to
estimate how many subnetworks and nodes per
subnetwork you need. See Chapter 2, “Networking
Concepts,” for details on deriving an IP subnet mask.
B nnn.nnn xxx.xxx
C nnn.mmm.mmm xxx
Where: nnn = the network portion of the IP address and
xxx = the node portion of the IP address.