HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 4
Preparing Your System
4.6 Creating the CSLT using HPINSTAL
86
b. hpinstal stages system libraries and creates the CSLT. This can take from one up to two and a half
hours.
Making a temporary copy of the SL... DONE
Making a temporary copy of the XL... DONE
Making a temporary copy of the NL... DONE
The installer will next update staged copies of
the System SL, XL, and NL
c. HPINSTAL updates the temporary copies of the system libraries and displays status messages:
Installing the SUBSYS and patch code, if any . . .
Modifying SL.INSTALL.SYS ... done
Translating SL.INSTALL.SYS ... done
Modifying XL.INSTALL.SYS ... done
Modifying NL.INSTALL.SYS ... done
Modifying System Intrinsics ... done
Creating a new START PME ... done
Creating the CSLT ...
Insert the second CD-ROM disk if prompted, then press
[Return]
.
The installer is done with the CD-ROM currently mounted.
Please remove the CD-ROM and insert the second CD-ROM, marked
MPE_v.uu.ff_2.
When the second CD-ROM volume is mounted, press RETURN to
continue >>
Thank You
Verifying the second CD-ROM . . . Done.
The second CD-ROM volume has been mounted.
Continuing with installing from the CD-ROM volume MPE_v.uu.ff_2.
14. After the CSLT is created, dismount the tape, label it CSLT v.uu.ff, and set it to read only.
The final response messages vary depending upon the CSLT option you selected. Basically, the response
is:
Phase I of HPINSTAL is now complete:
15. A warning message displays, if applicable.
WARNING -- This program cannot install the products listed below. (INSTWARN #1)
Record on your checklist any products HPINSTAL cannot completely install.
HPINSTAL will automatically cleanup files, exit, and return you to the MPE/iX prompt.
Purging temporary files and cleaning up...
16. If you are creating a CSLT on a local system to apply to a Remote system, proceed to Step 17.
If you are performing an Add-on or Update task for a local system only, omit Step 17, and go to the next
section on your checklist.
Remote Tasks
17. Refer to Appendix E, “CD-ROM Resources,” for directions on creating multiple copies of the CSLT with
the SLTCOPY command for use at remote systems.