HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)
Chapter 4
Preparing Your System
4.6 Creating the CSLT using HPINSTAL
85
a. Type two slashes (//) or
[Return].
b. Confirm the products as you did in Step 7.
10. Optionally, create a subset list of products from the full list of products.
This is typically done to create a CSLT for use on a remote system, but can be done for your local system
as well.
CAUTION If you customize the list of products, and if you selected HPINSTAL option 1 or 2, it will
create a CSLT with, and install, a subset of the master list of entitled products.
If you update your local system with a subset of the master list of products, you cannot use
HPINSTAL, option 6 or 7, to add products to the local system.You must use HPINSTAL, option
1 or 2, and customize the subset list of products.
To create a subset list of products:
a. Enter N to the prompt in Step 9.
The N option puts HPINSTAL into customization mode. HPINSTALL displays the list of products in the
current PRODLIST.install.sys file.
b. Review this list and make changes as needed.
Edit the file to create the list of products that will be installed using the CSLT. Use the CSLT created
in this section to modify your remote system.
11. If you are performing a PowerPatch task, proceed to Step 12.
If you are performing an Add-on or Update task without a PowerPatch, proceed to Step13.
PowerPatch Tasks
12. Restore patch information, qualify patches, and restore the patch files.
a. Mount the PowerPatch tape, as prompted.
b. Reply to the tape request.
c. Respond Y to accept the list of qualified patches, as prompted:
Do you wish to continue with the installation of the patches listed above(Y)? >>
d. Remount the PowerPatch tape, as prompted;
Mount the POWERPATCH tape and put the tape drive online.
The files from the POWERPATCH tape will now be restored.
e. Reply to the tape request.
f. Proceed to Step 13.
13. Create the CSLT.
Mount a write-enabled tape on the appropriate tape drive and reply to the tape request, as prompted.
This can take up to two and a half hours.
a. hpinstal determines the files that belong to your selected list of products.
Resolving product-level dependencies... DONE
Determining the subsystem files to be installed
... DONE