HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 4
Preparing Your System
4.6 Creating the CSLT using HPINSTAL
83
4.6 Creating the CSLT using HPINSTAL
This section describes how to create your Customized System Load Tape (CSLT) from CD-ROM source media
using the CD-ROM tool, hpinstal.
To create the CSLT using hpinstal
1. Start HPINSTAL.
:RUN HPINSTAL.INSTALL.SYS
2. Select the appropriate option. If you select a subsys option, your system software must be on the same
release level as the subsys product.
Please enter the number corresponding to the
software you want to install.
1 Update this system
2 Update this system and install patches from a PowerPatch tape
3 Create a CSLT for another system
4 Create a CSLT with PowerPatch patches for another system
5 Complete the update of this system using a CSLT created on
another system
6 Add SUBSYS products to this system
7 Add SUBSYS products and install patches from a Powerpatch
tape
8 EXIT
? Help on the above actions
Enter your choice >>_
3. Reply to the prompt for the LDEV number. Press
[Return]
to use the default of device class TAPE, or enter
the LDEV number of the device where you want the CSLT to be created. The device you specify applies to
all tape requests.
The file equation for the output device (where the CSLT is
created) defaults to DEV=TAPE. If you prefer to designate a
specific tape device, please enter its LDEV number now (RETURN
for default) >>
4. If you are creating a CSLT on a local system to apply to a Remote system, proceed to Step 5.
If you are performing an Add-on or Update task for a local system only, proceed to Step 6.
Remote Tasks
5. Respond to the prompt to specify a Base Group.
a. If you have not added customized files or a different configuration to your CSLT, press
[Return]
. This
is the typical condition.
b. If you have added customized files or a different configuration to your CSLT through the use of a
Base Group, specify that Base Group name now. (Refer to Appendix E, “CD-ROM Resources,” for
directions on creating a Base Group.)
When ready to create the CSLT, HPINSTAL will
copy your current configuration group to HPCONFIG.SYS and use that
as the base group. If you have customized a configuration group
that you would like HPINSTAL to use as the base group while creating
the CSLT, please provide it now.
Base group (RETURN for default) >>