HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Chapter 2
Task Checklists
Checklist H. Update with CD-ROM
45
Checklist H. Update with CD-ROM
Use this task checklist if your source material is on CD-ROM and you are using a CSLT tape to:
• Update your system software version level
• Update your system software version level and apply PowerPatch patches
NOTE You cannot apply Reactive patches at the same time you are updating the system. You must
apply Reactive patches after you update the system. To apply Reactive patches (after you
update the system) refer to the Checklist A, “Manage Patches,” or Checklist B, “Manage
Patches by Staging Area.”
Print a copy of this checklist for each system that you are updating. Read and perform the steps only in the
following sections:
Begin Preparation Tasks. Does not require exclusive access to the system.
Chapter 3, “Planning for Your Task.”
— 3.1 Verifying Required Materials
— 3.2 General Planning Tasks
— 3.3 CD-ROM Planning Tasks
— 3.4 Checking Tape Media
— 3.5 Checking Peripherals
— 3.6 Estimating Disk Space
Record contiguous disk space:
Record non-contiguous disk space:
Chapter 4, “Preparing Your System.”
— 4.3 Preparing to Run HPINSTAL
Record CD v.uu.ff version level:
— 4.6 Creating the CSLT using HPINSTAL
Record manually installed products:
— 4.12 Reserving Disk Space for CD-ROM Tasks
Record contiguous disk space:
Record non-contiguous disk space:
Preparation Tasks completed. Schedule downtime for exclusive access.
If you are not applying this update to a master system, and instead are only creating a CSLT on a master
system to apply to a remote system, you can now proceed to the Checklist I, “Modify Remote System.”
Begin Exclusive Access Tasks.
Chapter 5, “Modifying Your System.”
— 5.11 Securing the System