HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
403
STAGEMAN) in another job or session, since STAGEMAN always opens
the relevant staging area contents file for exclusive access during the
execution of each command.
Action Either terminate the additional STAGEMAN process, or allow the
command being executed by that process to complete. The command can
then be re-executed (or the Patch/iX process restarted).
1173 Message Failed to open the contents file for “name”.FSERR = value (STAGEMAN
1173)
Cause STAGEMAN received a bad status from the file system while attempting
to open the staging area's contents file (the name of the contents file is
/SYS/hpstage/stage_name/stage_contents).
Action Determine the cause of the file open failure, correct the problem, then
re-execute the command (or restart the Patch/iX process).
1174 Message No contents file found in “name”. Can'tdo command. (STAGEMAN 1174)
Cause STAGEMAN expected the staging area or directory to contain a contents
file (for example, /SYS/hpstage/stage_name/stage_contents), which stores
critical information about the corresponding staging area. However, the
contents file was not found.
Action Check the spelling of the staging area name.
1180 Message STAGEMAN error numbers are in the range 1001 - 1999. (STAGEMAN
1180)
Cause An ERRMSG command was issued with an error number that is out of the
range of STAGEMAN’s error messages.
Action Re-execute the command with a valid STAGEMAN error number. The
error number is always displayed at the end of a STAGEMAN error
message.
1181 Message “name” is not currently a STAGEMAN error number. (STAGEMAN 1182)
Cause STAGEMAN received a bad status from the DBINARY intrinsic call while
attempting to convert the user's ERRMSG input to an integer.
Action Contact your Hewlett-Packard Response Center for assistance.
1182 Message “name” is not currently a STAGEMAN error number. (STAGEMAN 1182)
Cause The user entered a number for ERRMSG that currently does not
correspond to a STAGEMAN error number.
Action Re-execute the command with a valid STAGEMAN error number. The
error number is always displayed at the end of a STAGEMAN error
message.
1183 Message CATREAD failed in reading text from the STAGEMAN catalog.
CATREAD Error = value (STAGEMAN 1183)
Cause STAGEMAN received a bad status from the CATREAD intrinsic while
attempting to read a message from the STAGEMAN catalog,
STAGE000.PUB.SYS.
Action Contact your Hewlett-Packard Response Center for assistance.
1184 Message Found no cause/action text corresponding to “name”.(STAGEMAN 1184)