HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
400
Cause STAGEMAN received a Command Interpreter (CI) error in attempting to
perform an ALTFILE command on the file to change its owner attribute.
Determine why the ALTFILE command failed. You can either re-execute
the command after the problem is fixed, or just manually alter the owner
with the ALTFILE CI command.
1135 Message FROM file “name” does not exist. (STAGEMAN 1135)
Cause The file specified in the FROM parameter does not exist.
Action Determine why the file does not exist, correct the problem, then re-execute
the process. If this error occurred during a run of Patch/iX, then contact
your Hewlett-Packard Response Center for assistance.
1136 Message FROM file “name” did not exist, but staged version did. No move done.
(STAGEMAN 1136)
Cause This warning is issued when STAGEMAN discovers that the file specified
in the FROM parameter does not exist, but a version of the file does
already exist in the staging area. This is a normal occurrence when
Patch/iX is using STAGEMAN to stage files into a staging area while
Patch/iX is in recovery mode (for instance, if it previously failed in the
middle of staging files).
Action None
1137 Message Failed to set the ACD on file “name”.CIERROR = value (STAGEMAN
1137)
Cause STAGEMAN received a Command Interpreter (CI) error in attempting to
do an ALTSEC command to replace the current ACD on the staged file.
Action Contact your Hewlett-Packard Response Center for assistance.
1138 Message Failed to open staged file “name”. (STAGEMAN 1138)
Cause STAGEMAN received a bad status from the HPFOPEN intrinsic while
attempting to open a staged file for getting data on the file.
Action Determine why the file open failed. If you can determine and fix the
problem re-execute the command (or restart the Patch/iX process).
Otherwise, contact your Hewlett-Packard Response Center for assistance.
1139 Message Failed in FFILEINFO call for file “name”. (STAGEMAN 1139)
Cause STAGEMAN received a bad status from the FFILEINFO intrinsic while
attempting to get data on a staged file.
Action Contact your Hewlett-Packard Response Center for assistance.
1140 Message Failed to open file “name” for getting LIF information. (STAGEMAN 1140)
Cause STAGEMAN could not open the file. The reason is stated in the file system
error message that appears above this one.
Action Determine why the file could not be opened, correct the problem, then
re-execute the command or process.
1141 Message Failed in FFILEINFO call for file “name”. (STAGEMAN 1141)