HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)
Appendix H
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
395
Cause The DUPLICATE operation failed, and to remove the possibility of leaving
behind a corrupt target (TO) staging area, STAGEMAN attempted to
delete the target staging area. However, an error occurred during the
delete operation. The status of the target staging area is unknown at this
point.
Action Determine why the delete of the bad target staging area failed. Contact
your Hewlett-Packard Response Center for assistance if necessary.
1087 Message Failed to rename staging area “name1” to “name2”. Status: Subsys =
value, Info = value (STAGEMAN 1087)
Cause The ;NAME= parameter of the CHANGE command was selected, but
STAGEMAN received an error while trying to rename the staging area
directory (/SYS/hpstage/old_name --> /SYS/hpstage/new_name).
Action Contact your Hewlett-Packard Response Center for assistance.
1088 Message The new staging area name is the same as the old one.
(STAGEMAN 1088)
Cause The ;NAME= parameter of the CHANGE command was selected, but the
new name supplied for the staging area was the same as the current
staging area name.
Action None.
1089 Message No parameters were given. No action taken. (STAGEMAN 1089)
Cause A command was issued that expected one or more parameters, but no
parameters were provided, so STAGEMAN did nothing.
Action None.
1090 Message The HP Stage/iX environment is not initialized. (STAGEMAN
1090)
Cause This is a warning issued by STAGEMAN at startup time to tell the user
that the environment is not initialized. This is normal the first time
STAGEMAN is run on a newly installed system.
Action None necessary. Do a HELP on INITIALIZE for more information.
1091 Message One or more problems were encountered while processing
the STAGEDEF file. (STAGEMAN 1091)
Cause STAGEMAN could not process the file STAGEDEF.PUB.SYS at startup
time. STAGEDEF is used by STAGEMAN to get default attributes of
known system files. This is a warning because it will not interfere with
most STAGEMAN commands or operations. However, if files need to be
staged (for instance, if Patch/iX is creating staging areas), this is a serious
error.
Action Determine why STAGEMAN did not execute the STAGEDEF file. You can
process the file explicitly from the STAGEMAN prompt by doing the
following:
STAGEMAN> EXPERT ON
STAGEMAN> OPTION LIST
STAGEMAN> USE STAGEDEF.PUB.SYS
1092 Message Can't set the STAGEMAN CI variable “name”. (STAGEMAN 1092)