HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
394
Action None
1080 Message Indirect file “name” does not exist. (STAGEMAN 1080)
Cause The ;EXCEPT parameter was used on a DUPLICATE command, however
the indirect file specified for the parameter does not exist.
Action Check your spelling on the indirect file name.
1081 Message Unable to open indirect file “name”. (STAGEMAN 1081)
Cause The ;EXCEPT parameter was used on a DUPLICATE command, and
STAGEMAN received a file system error from an HPFOPEN intrinsic call
to open the indirect file.
Action Determine why the HPFOPEN intrinsic call failed, correct the problem,
and re-execute the command.
1082 Message Unable to obtain information about indirect file “name” (STAGEMAN
1082)
Cause The ;EXCEPT parameter was used on a DUPLICATE command, and
STAGEMAN received a file system error from an FFILEINFO intrinsic
call for indirect file.
Action Determine why the FFILEINFO intrinsic call failed. Contact your
Hewlett-Packard Response Center for assistance if necessary.
1083 Message Record size for indirect file “name” exceeds max () (STAGEMAN 1083)
Cause The ;EXCEPT parameter was used on a DUPLICATE command, however
the record size of the indirect file specified exceeds the limit of 256 bytes.
Action Use an indirect file that has a record size of <= 256 bytes.
1084 Message File “name” has a disposition of DELETE, but a version of the file exists in
the staging area. (STAGEMAN 1084)
Cause The file was staged with a disposition of DELETE (meaning the file should
be deleted from its natural location when the staging area is activated),
but a version of the file exists in the staging area.
Action Purge the file from the staging area's directory
(/SYS/hpstage/stage_name/). If the file should not have a disposition of
DELETE, then re-stage the file (do an Expert Mode HELP on
STAGEFILE for more information) with a different disposition.
1085 Message Duplicate failed. Deleted incomplete staging area “name”. (STAGEMAN
1085)
Cause A DUPLICATE operation failed, and to remove the possibility of leaving
behind a corrupt target (TO) staging area, the target staging area was
deleted. This error normally prints after an initial DUPLICATE error is
printed, and is therefore issued for information purposes only.
Action Reference the DUPLICATE error that immediately preceded this one to
help determine the cause of the problem.
1086 Message Failed to delete bad staging area “name”. (STAGEMAN 1086)