HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
386
Action Check your spelling on the staging area parameter, choose a different
staging area name, or delete the existing staging area.
1029 Message A directory by the name of “name” already exists. Can’t command.
(STAGEMAN 1029)
Cause STAGEMAN found a directory under /SYS/hpstage/ of the same name
that was used for the staging area parameter. Since STAGEMAN uses the
staging area name for building a directory under /SYS/hpstage/
(/SYS/hpstage/stage_name), it fails on this condition to avoid corrupting
the user's environment. If an unexpected staging area directory exists
that is not recognized as a staging area in the HP Stage/iX environment, it
usually means one of two things: 1) the staging area was restored from
backup and was not recovered into the HP Stage/iX environment, or 2) the
directory was manually created by a user.
Action For Case 1 (above), do a RECOVER to pull the staging area into the HP
Stage/iX environment (do a HELP on RECOVER for more information).
For Case 2, purge the directory, or choose another staging area name. If
neither of these cases applies, contact your Hewlett-Packard Response
Center for assistance.
1030 Message Failed to purge an old copy of the EXPORT indirect store file “name”.
CIERROR = value (STAGEMAN 1030)
Cause STAGEMAN needed to remove an old copy of the indirect store file so it
could create a new one, but could not purge the file.
Action Determine why the file could not be purged, fix the problem, and redo the
command.
1031 Message Failed to create the EXPORT indirect store file “name”. FSERR = value
(STAGEMAN 1031)
Cause STAGEMAN got a file system error back while trying to create an indirect
store file for storing a staging area.
Action Determine why the file could not be created, fix the problem, and redo the
command.
1032 Message Failed to FWRITE to the EXPORT indirect store file “name”.
(STAGEMAN 1032)
Cause STAGEMAN got a file system error back from the FWRITE intrinsic while
trying to build the indirect store file for storing a staging area. One
possibility is that the file was full.
Action Contact your Hewlett-Packard Response Center for assistance.
1033 Message Failed to store the EXPORT indirect store file “name”. CIERROR = value
(STAGEMAN 1033)
Cause STAGEMAN got an error back from STORE while trying to store a
staging area to tape. This error will always be reported if a REPLY ,0 was
done to the tape request.
Action Determine why the STORE command failed, fix the problem, and redo the
command.
1034 Message Can't use reserved word “IMPORT” for staging area name.
(STAGEMAN 1034)