HP e3000 MPE/iX System Software Maintenance Manual (Release C.75.00) (30216-90344)

Appendix H
Error Messages and Warnings
Installer Error Messages (INSTERR)
375
Cause The installer is attempting to access an invalid file as an intermediate
TMPSTR file.
Action • Run the installer again, and answer “no” when asked if you wish to
continue with the previous run.
• Contact the Response Center for further assistance.
251 Message The installer failed to read !1. Components may have
not been successfully added to the !2 library. (INSTERR #251)
Cause The installer encountered an error while reading the file.
Action • Ensure that the file is not being accessed by another process.
• Run the installer again.
• Contact the Response Center for further assistance.
252 Message The installer failed to properly access !1. No components
have been added to the !2 library. (INSTERR #252)
Cause The first record of the data file could not be accessed.
Action • Ensure that the file is not being accessed by another process.
• Ensure that the file is in the appropriate format. (Each record must
contain the name of an MPE file that contains the library
replacement, and a unique entry point into the library component.
The file name and the entry point must be separated by a comma).
• Run the installer again.
• Contact the Response Center for further assistance.
253 Message The installer failed to open !1. No components have
been added to the !2 library. (INSTERR #253)
Cause The installer failed when attempting to open the file.
Action • Ensure that the file is not being accessed by another process.
• Ensure that the file is in the appropriate format. (Each record must
contain the name of an MPE file that contains the library
replacement, and a unique entry point into the library component.
The file name and the entry point must be separated by a comma).
• Run the installer again.
• Contact the Response Center for further assistance.
254 Message The file !1 is in an invalid format. Each record in
the file should contain a file name and a library entry,
separated
by a comma. (INSTERR #254)
Cause The specified input file is not in the appropriate format to be recognized by
HPINSTAL. The file must be an ASCII file with a record size of 80 bytes.
Each record must contain the name of an MPE file that contains the
library replacement, and a unique entry point into the library component.
The file name and the entry point must be separated by a comma, e.g:
ESSRL.ISSIT.SYS,ESS2XREF. In this example, the name of the file is
ESSRL.ISSIT.SYS. The entry point is ESS2XREF.